Needing a little help here please. We have an environment with no router, but we do have a layer 3 switch. Please refer to the diagram; we have a server with IP address 192.168.1.3 connected to Ethernet port 1 of the Brocade Ruckus ICX 7150 switch. We have a fiber link on port 9 that goes out to a layer 2 switch. On port 9 we have virtual interfaces for vlan 51 at 10.174.241.99 and vlan 351 at 184.108.40.206. From the Brocade Ruckus we can ping the Camera at 220.127.116.11, so we are routing traffic as intended from the Brocade through the layer 2 switch (that has tagging) to the camera at 18.104.22.168. What we need to do is have the server connect from its IP address of 192.168.1.3 to the camera at 22.214.171.124. What configuration method would work best to achieve this goal?
Firewall was turned on at the server blocking our pings. We can now ping from the ICX 7150 switch to the server, however the server still cannot ping the ve addresses of 10.174.241.99 or 126.96.36.199, or the end devices at 10.174.241.20 and 188.8.131.52. Any ideas? Help please.
We've made a few updates since this was posted, but we still can't communicate across the subnets. I realize I left off a lot of information while trying to stick to the basics. We've figured a lot out, but we're not there yet. We made a VE on port 1/1/1 of the ruckus and assigned it vlan 192 with ip 192.168.1.1. We set the gateway of the server to 192.168.1.1. We can now ping the gateway on the switch, and from the switch we can ping the server. We still cannot ping across the subnets.
The fiber port isn't on port 9, it's actually on port 1/3/1.
We've added the static routes below on the server, but it didn't help, still can't ping the camera at 184.108.40.206.
Our original configurations left out gateway as we had no router and were working on layer 2. After adding the layer 3 switch with ve's we never went back and added the gateways. Once we added the ve ip's as the gateways for each device in its subnet it worked like a charm.