Hello, my ICX 7150 is stuck in Recovery Mode, and I am trying to update the images via TFTP. I followed the post below, and I was able to ping the host. However, I was stuck in the final step when updating the image. How to perform a Software recovery on an ICX7150 switch
I have a feeling it's the TFTP server's problem, but I am unsure what's wrong.
Any advises, comments, and ideas are appreciated.
Thank you!
ICX7150-Boot>printenv
baudrate=9600
ipaddr=192.168.0.3
serverip=192.168.0.2
netmask=255.255.255.0
gatewayip=192.168.0.2
uboot=mnz10115.bin
image_name=SPS08090k.bin
ver=10.1.15T225 (Jan 30 2019 - 23:08:47 -0800)
Environment size: 189/16379 bytes
ICX7150-Boot>ping 192.168.0.2
Change GMAC speed to 1000MB
Using bcm_xgs_gmac-0 device
host 192.168.0.2 is alive
ICX7150-Boot>update_primary
Updating PRIMARY image over TFTP
Load addr=0x70000000
Change GMAC speed to 1000MB
Using bcm_xgs_gmac-0 device
TFTP from server 192.168.0.2; our IP address is 192.168.0.3
Filename 'SPS08090k.bin'.
Load address: 0x70000000
Loading: T T T T T T T T T T
Retry count exceeded; starting again
