i am trying to configure 802.1x for our ruckus switches which are manged in ruckus one.
i used the cli to add the radius server, enable dot1x etc.
but when i try to show the dot1x configuration i get:
SSH@wsw02_Serverraum(config-authen)#show dot1x configuration[
Invalid input ->configuration[
Type ? for a list
Node doesn't exist
any ideas here?
Thank you for reaching out to Ruckus Forum.
As many of the commands has been deprecated in newer releases and replaced by new commands.Please use the show authentication session and show authentication configuration, in place of show dot1x command.Please find the below links for the security guide and command reference guide for a reference.https://support.ruckuswireless.com/documents/4027-fastiron-09-0-10-ga-security-configuration-guidehttps://docs.commscope.com/bundle/fastiron-09010-commandref/page/GUID-E880F9D0-583A-4BCC-A448-BA8B07...
Zairah JaveedSr Technical Support Engineer | L2 TAC Wiredsupport.ruckuswireless.com/contact-us
COMMSCOPEnow meets next
Note: Please feel free to mark the post as ACCEPTED SOLUTIONS