This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject

 

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

 

Ruckus Wireless
RUCKUS Self Help |   ASK the Pack
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

R610 only showing 100 Mbps speed

Anonymous
Not applicable

‎08-22-2020 04:06 PM

I have a R610 AP connected to an ICX-7150-C12P switch using unleashed. The AP set up as a member AP and is connected via Cat6 to the switch. The AP connects at 100 Mbps whereas the Master AP is connecting at 1 Gbps. I tried to configure the port using "speed-duplex 1000-full" via telnet but that caused the port completely lose the connection (so I set the port back to auto). Not sure what else to try since the AP and switch should support full 1 Gbps.
Reply
5 REPLIES 5

reinaldo_dharma
New Contributor

‎08-30-2023 11:35 PM

I often experience things like this, normally the interface reads 2.5Gbps, but a few days later it drops to 100Mbps. I tried crimping again but it only lasted a while.

0 Kudos
Reply
Copyright © 2026 Khoros, LLC