PC can't "see" router through ICX 7150 switch

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Edit: Turns out the router was jacked into the out-of-band management port instead of one of the network ports. D'oh!

----------------

I've inherited an ICX 7150 (version 08.0.61aT211 (SPS08061a.bin)) as part of a rental unit. I factory reset the switch, disabled DHCP and (I think) DNS on the switch, and set the default gateway to the Router's IP address.

The network setup and connectivity looks like this:

ONT/Router <-eth-> ICX 7150 <-eth-> PC: PC can see switch, can't see router or internet
ICX 7150 <-eth-> ONT/Router <-wifi->PC: PC can see router, switch, and internet

The switch is misconfigured somehow and not sending traffic between connected devices. Any suggestions where to start first? Thanks

1 REPLY 1