03-18-2023 08:43 PM
My APs are not receiving power (no lights present) after the ICX-7150-12CP switch was disconnected from power, the switch has two lights present (see attached picture). I read through similar posts on here and followed steps to console the switch with USB-C to USB, which I was able to do. I also followed steps to perform a software recovery but was unsuccessful as I received the following:
ICX7150-Boot>setenv ipaddr 192.168.0.3
ICX7150-Boot>setenv gatewayip 192.168.0.2
ICX7150-Boot>setenv netmask 255.255.255.0
ICX7150-Boot>setenv serverip 192.168.0.2
ver=10.1.15T225 (Jan 30 2019 - 23:08:47 -0800)
Environment size: 189/16379 bytes
bcm_xgs_gmac-0 Waiting for PHY auto negotiation to complete......... TIMEOUT !
Auto-neg error, defaulting to 10BT/HD
Change GMAC speed to 10MB
Using bcm_xgs_gmac-0 device
ARP Retry count exceeded; starting again
ping failed; host 192.168.0.2 is not alive
I am not sure if the error was due to not being connected with an Ethernet, the step in which I was required to input an IP address was to be done through an Ethernet properties (see step below), however, my laptop does not have an Ethernet port so I used the properties for the Bluetooth and WiFi (see attached pic). Since I received an error I am unsure what to do next.
Start>type control panel>View network status and Task>change adapter setting>Ethernet>right click properties>Internet Protocol (TCP/IPv4)>Select Use the following IP address>insert the same information I have>Click OK
03-19-2023 02:59 AM - edited 03-19-2023 04:23 AM
Hi Ampersand ,
Thank you for posting your query !!!
I understand that your APs are not receiving power (no light present) after the
ICX-7150-12cp switch was disconnected from the power .And I also notice that
you have tried a software recovery but no luck over there and you are getting
I also notice that from the image you provided that the unit is having amber light . And When the SYS light is amber that means that the switch is stuck in boot mode.
I have a question for you here :
1> Did you try to boot the ICX 7150-12cp from primary and secondary image from service os .If not try to boot the primary or secondary partition like this: boot_primary or boot_secondary.
Regarding the error which you are getting it seems you are not reachable to the default gateway ip=192.168.0.2 that is you laptop in this case . So make sure you laptop is having a TFTP server application with reachability towards the ICX .And make sure you have Ethernet cable connectivity from your ICX to laptop because here Wi-Fi and Bluetooth connectivity wont help .
Could you please try again the software recovery method by following the below video link .
Please let us know how it goes.
Moving Forward If this issue is not resolved , Please log a ticket with the below link so that we will help you to process RMA
I hope this information helps you
Please feel free to leave us a message if any concerns
Note: Please feel free to mark the post as ACCEPTED SOLUTIONS if its addressed your query.
03-19-2023 07:59 AM
Thank you for the quick reply. In the response I was told to “make sure you have Ethernet cable connectivity from your ICX to laptop because here Wi-Fi and Bluetooth connectivity wont help”, however, as I stated in the initial post I stated I do not have an Ethernet post, how would I proceed in this instance?
03-19-2023 11:21 AM
There is no way , other than using ethernet port connectivity between laptop and ICX to Perform software recovery Hope that helps !
03-19-2023 11:32 AM
That does no make any sense to me as the instructions are also for a USB to USB-C cable.