In cisco, the configuration is displayed such that interface is displayed first and vlan tagging or untagging is secondary.
Is there a command in ruckus so that I check the vlan tagging based on port, especially for the show run?
Can I enter the vlan tagging after going into the interface first?
Hello @BusinessUser ,
You can use " show vlan " command to check the tag and untag ports associated with particular vlan
Also you can tag /untag the port by going into the vlan and then using tag/untag command
#tagged/untag ethernet <>
! Management VLAN configuration.
SCH-ACCESS-101(config)# vlan 10 by portSCH-ACCESS-101(config-vlan-10)# untag ethernet 1/1/1 to 1/1/4SCH-ACCESS-101(config-vlan-10)# management-vlanSCH-ACCESS-101(config-vlan-10)# default-gateway 10.10.10.1 1SCH-ACCESS-101(config-vlan-10)# default-gateway 10.20.20.1 2
! User VLAN configuration.
SCH-ACCESS-101(config)# vlan 1011SCH-ACCESS-101(config-vlan-1011)# tagged ethernet 1/1/13 to 1/1/17 ethernet 1/2/2 ethernet 1/2/4 ethernet 2/2/2 ethernet 2/2/4SCH-ACCESS-101(config-vlan-1011)# untagged ethernet 1/1/12SCH-ACCESS-101# show vlan 1011Total PORT-VLAN entries: 14Maximum PORT-VLAN entries: 64Legend: [Stk=Stack-Id, S=Slot]PORT-VLAN 1011, Name data_vlan, Priority level0, Spanning tree OnUntagged Ports: (U1/M1) 12Tagged Ports: (U1/M1) 13 14 15 16 17Tagged Ports: (U1/M2) 2 4Tagged Ports: (U2/M2) 2 4Uplink Ports: NoneDualMode Ports: NoneMac-Vlan Ports: NoneMonitoring: Disabled
For your reference below is the link of the guide which shows tagging and untagging part:
Zairah JaveedSr Technical Support Engineer | L2 TAC Wiredsupport.ruckuswireless.com/contact-us
COMMSCOPEnow meets next
Note: Please feel free to mark the post as ACCEPTED SOLUTIONS
Can I start by going into the interface first?
Just like cisco int xxx, switchport mode access,
Hi @BusinessUser1 ,
We can do other configurations by adding to interface but tagging and untagging can be done via vlan
So I assume that the answer is no?