10-21-2022 11:39 AM
New to Ruckus as we have had all of our Cisco switches replaced with ICX switches.
I'm trying to find out how to find the IP address of connected devices. In Cisco, I enabled device-tracking on the ports and I could see the IP address of the device connected to the port.
Does something like that exist in the Ruckus world?
10-21-2022 12:49 PM - edited 10-21-2022 12:50 PM
Hope you are doing well !
ICX7250-24P Switch#show arp
Total number of ARP entries: 4
Entries in default routing instance:
No. IP Address MAC Address Type Age Port Status
1 192.168.0.2 3420.e323.9760 Dynamic 0 1/1/4 Valid
2 192.168.0.3 60d0.2c1c.1cd0 Dynamic 0 1/1/2 Valid
3 192.168.0.4 2479.2a25.ed00 Dynamic 0 1/1/3 Valid
4 192.168.0.20 0050.56ab.abd8 Dynamic 0 1/1/1 Valid
Show arp Ethernet x/x/x ( Where each x means Unit / module / port )
ICX7250-24P Switch#show arp ethernet 1/1/2
1 192.168.0.3 60d0.2c1c.1cd0 Dynamic 0 1/1/2 Valid
If the device that is connected is compatible with LLDP you can enable lldp
ICX7250-24P Switch# show lldp neighbors detail
Local port: 1/1/2
Neighbor: 60d0.2c1c.1cd0, TTL 104 seconds
+ Chassis ID (MAC address): 60d0.2c1c.1cd0
+ Port ID (MAC address): 60d0.2c1c.1cd0
+ Time to live: 120 seconds
+ System name : "RuckusAP"
+ System description : "Ruckus R710 Multimedia Hotzone Wireless AP/SW Version: 126.96.36.199.129"
+ System capabilities : bridge, WLAN access point, router
Enabled capabilities: bridge, WLAN access point
+ Management address (IPv4): 192.168.0.3
+ Port description : "eth0"
+ Link aggregation: capable, but not aggregated
+ 802.3 MAC/PHY : auto-negotiation enabled
Advertised capabilities: 10BaseT-HD, 10BaseT-FD, 100BaseTX-HD,
Operational MAU type : 1000BaseT-FD
+ 802.3 Power via MDI: PD port + Unknown Organizationally-Specific TLV: OUI 000142, subtype 1
Value: (binary) "05"
Where 192.168.0.3 is the IP address of the Access Point that is connected on port 1/1/2
10-22-2022 09:37 AM
Just adding few links to the post for reference and for more details.