ICX7250P POE Daughterboard Replacement?

[dan_dare]

Hi

I have obtained a ICX7250P with 08.0.95ba Firmware

The switch works normally, but the POE Module Reports:- Severe Error - Module Failed to Init.

I have reloaded the Boot, Image and POE Firmware with no effect.

The switch works normally, the POE module fails to initialise.

On closer internal inspection this unit has a defective POW Daughterboard, please see the attached picture. The “MSC” IC is burned.

Is it possible to obtain a replacement POE daughterboard?

Is it possible to just remove this daughterboard and use it as a Non-POW switch?

Any insight will be really appreciated.

Thanks in advance.

Dan

[jijo_panangat]

Hi Dan,

You can reach out to the support team with serial number of the switch and request an RMA. ICX switches have a limited lifetime warranty. 
Warranty only applies to the original owner of the product, and doesn't cover environmental damage, misuse, and a variety of other exclusions that are explicitly mentioned in the document referenced in support site.

Hope it helps