hello Newbie question. I am trying to connect a ZD1200 via an ICX 7150 switch to H510 APs. vlan 1 is native /Vlan 20 public ssid /Vlan 30 for members / Vlan 40 for media and Vlan 100 for wired connections.
I have the following config but unable to get the ZD on port 1/1/1 to connect to the APs on ports 1/1/3 - 1/1/12.
The port for the ZD does not need to be tagged in any VLAN. It only needs to be untagged in your management VLAN (I assume VLAN 10). It will work the way it is setup, but it is not a best practice.
For the H510, You need to tag ports 1/1/3 to 1/1/11 on VLANs for the wireless, management, and wired ports on the AP. You will need to set the VLAN for the wired ports on the H510 as your Dual-mode VLAN, and configure the management VLAN in the AP configuration of the ZD.
VLAN 10 (Assumed Management) untagged e 1/1/1 - ZD Port
Another thing I notice is you have routes defined on interface 1/2/1 but
no IP address assigned. This will be insufficient to work. You need to
either assign an IP address to eth 1/2/1 which will make it a routed
port (consider use of route-only command in that case on 1/2/1) or
preferably use another VLAN and asign it untagged on eth 1/2/1 with the
routes pointing to the corresponding VE.
For extra brownie points, consider
int eth 1/1/3 to 1/1/12 port-name WAPs
int eth 1/1/1 port-name "SZ1200 ctrlr"
or similar. This will make it easier to follow in the future what you intended. Also, use
or show vlan eth x/y/z to understand better what your current config is achieving. The output is a little hard to follow at first but it is comprehensive.
btw the dual-mode 10 on eth 1/1/1 was perfectly valid but as David Ellis says, you don't need any other VLAN so untagged or dual mode much of a muchness.
Also maybe the below
vlan 10 by port tagged ethe 1/1/1 ethe 1/1/11
was supposed to be
vlan 10 by port tagged ethe 1/1/1 to 1/1/12
What about a management ve for VLAN 10 so you can talk to the controller and what of address assignment for APs? These are not in align atm.