cancel
Showing results for 
Search instead for 
Did you mean: 

How do I know if my switch has route image or switch image

atulchoudhary
New Contributor

How do I know if my switch has route image or switch image?

Does this R indicates router mode? Is there any way I can know this from show flash itself or some other command which doesn't need booting with image first?

UNIT 1: compiled on Dec 17 2014 at 18:38:51 labeled as FCXR08010g

 

Stack unit 1:

  Compressed Pri Code size = 7280225, Version:08.0.10gT7f1 (/foundry/FGS/os/FCXS08010g.bin)

  Compressed Sec Code size = 9675881, Version:08.0.10gT7f3 (/foundry/FGS/os/FCXR08010g.bin)

  Compressed Boot-Monitor Image size = 370695, Version:10.1.00T7f5

  Code Flash Free Space = 48234496

 

 

sh version 

  Copyright (c) 1996-2014 Brocade Communications Systems, Inc. All rights reserved.

    UNIT 1: compiled on Dec 17 2014 at 18:38:51 labeled as FCXR08010g

(9675881 bytes) from Secondary /foundry/FGS/os/FCXR08010g.bin

        SW: Version 08.0.10gT7f3 

  Boot-Monitor Image size = 370695, Version:10.1.00T7f5 (grz10100)

  HW: Stackable ICX6610-48

==========================================================================

UNIT 1: SL 1: ICX6610-48 48-port Management Module

  Serial  #: BXL1312K0HH

  License: ICX6610_PREM_ROUTER_SOFT_PACKAGE   (LID: dzpINGKnFjp)

  P-ENGINE  0: type E02B, rev 01

  P-ENGINE  1: type E02B, rev 01

==========================================================================

UNIT 1: SL 2: ICX6610-QSFP 10-port 160G Module

==========================================================================

UNIT 1: SL 3: ICX6610-8-port Dual Mode(SFP/SFP+) Module

==========================================================================

  800 MHz Power PC processor 8544E (version 0021/0023) 400 MHz bus

65536 KB flash memory

  512 MB DRAM

STACKID 1  system uptime is 7 days 19 hours 48 minutes 51 seconds 

The system : started=warm start reloaded=by "reload"

 

1 ACCEPTED SOLUTION

BenBeck
Moderator
Moderator

You are correct. FCXS would denote switching image and FCXR would denote routing image. You can check 'show version' to see what is currently running. 'show flash' will give you the contents of both primary and secondary flash. 

Ben Beck, RCNA, RCNI, Principal Technical Support Engineer
support.ruckuswireless.com/contact-us

View solution in original post

3 REPLIES 3