Hello. There is a problem. I have a Fastiron Edge X648-prem switch (ver. 07.4.01T3e5), I want to install a 2x10G board on it, took it from a friend, but after installing the switch it is not launched, the IP4 conflict writes. I think I need another firmware. Tell me what. Thank you in advance.
It looks like the linecard is IPv6 while your chassis is IPv4. I'm not sure if it is even possible anymore as the switch it end of support, but you used to be able to upgrade the chassis via "FESX648-L3U-IPV6" license. I think that would be the only way to use the IPv6 module.
Ben Beck, RCNA, Principal Technical Support Engineer support.ruckuswireless.com/contact-us