8200 has no RDS mode

[Niacom]

Hello,

Purchased an 8200 24P, I am a bit confused, both primary and secondary are RDR, how do I flash an RDS onto the primary as like in the 7150's?

Thank you

[BenBeck · Accepted solution]

Switching image was deprecated with 10.0 and each platform will only use one image starting with 10.0. Switching features are still available in the routing image. Hope this helps!

[Niacom]

Thank you for the information. 

[jzsjr]

So in 8.0.95 layer 2 I could still assign the switch an IP using >ip address 172.16.x.x/24 and then assign >ip default-gateway 172.16.x.1/24.  Those don't seem to be available commands.  Is there something I need to turn on before deploying layer 2 commands or is there another way to go about this?

[BenBeck]

You will need to put an IP address on a VE, a physical interface or the mgmt port itself. You should use 'ip route 0.0.0.0/0 <GW-address>' to define a default route.