ukus h510 after upgrading firmware to unleashed am not able to remove access point previously configured it is still enable and

[begue_john_stew]

Hi i have Rukus h510 after upgrading firmware to unleashed am not able to remove access point previously configured it is still enable and

[begue_john_stew]

thanks this doc was very useful too.

[begue_john_stew]

Hi thanks again for your quick response.
After factory reset i install the only the unleashed firmware will it be working solo  standalone access point? 

[begue_john_stew]

Hi 10 sec on hard reset . it reset only the configuration of the unleashed,

[Ankush_Chandan]

Yes, Since it is upgraded to Unleash firmware, it will just reset the configuration by pressing the reset button. Firmware will remain the same.

Regards,
-Ankush

[begue_john_stew]

Hi Ankush,

Sorry for disturb.

I found The issue, it was not with the H510 .
I checked in rogue devices found its was another device configured with the same SSID same password.
Found the device disconnected it, everything is fine.
I should have checked in the rogue devices first.

Thanks a lots for your assistance. looking forward to work with you again.
Thanks 
Regards John.