cancel
Showing results for 
Search instead for 
Did you mean: 

ukus h510 after upgrading firmware to unleashed am not able to remove access point previously configured it is still enable and

begue_john_stew
New Contributor II
Hi i have Rukus h510 after upgrading firmware to unleashed am not able to remove access point previously configured it is still enable and
10 REPLIES 10

thanks this doc was very useful too.

begue_john_stew
New Contributor II
Hi thanks again for your quick response.
After factory reset i install the only the unleashed firmware will it be working solo  standalone access point? 

begue_john_stew
New Contributor II
Hi 10 sec on hard reset . it reset only the configuration of the unleashed,

Yes, Since it is upgraded to Unleash firmware, it will just reset the configuration by pressing the reset button. Firmware will remain the same.

Regards,
-Ankush

Hi Ankush,

Sorry for disturb.

I found The issue, it was not with the H510 .
I checked in rogue devices found its was another device configured with the same SSID same password.
Found the device disconnected it, everything is fine.
I should have checked in the rogue devices first.

Thanks a lots for your assistance. looking forward to work with you again.
Thanks 
Regards John.