Hi i am deploying (3) R300 access points without the zone director. We would like to run the wireless on a different Ip range as the wired lan and not have the wireless clients able to connect to any resources on the wired lan. is that possible with only the access points?
thank you for the response. i setup the access points using the option for the separate subnet and dhcp so the wireless clients are receiving ip addresses that are different from the lan range but in testing i am still able to reach the lan from a wireless client. The access points are connected to a net gear ProSafe FS728TPv2. do you know if that is an L3 switch and can it do what i need?
Hello Sean thank you for the reply. I tired the setup with my netgear switch based on your instructions and once I do I cannot connect to the Internet. I already had the separate subnet setup in the access point so my wireless clients are receiving alternate ip addresses apart from the lan but like I said when I tried following the instructions they could no longer reach the Internet. Is it possible a step may be missing?