cancel
Showing results for 
Search instead for 
Did you mean: 

convert unleashed ruckus r610 to standalone ap

alan_tam_ell5st
New Contributor III
Hi,

    I will like to convert ruckus R610 to standalone AP that can managed by Zone director 1200 with firmware 9.13.3.0 build 41. What is the firmware that I need to download?

    Thanks.

alan
6 REPLIES 6

DarrelRhodes
Contributor III
Hi Alan,

You need the standalone firmware, download it from our support site here: https://support.ruckuswireless.com/software/1727-zoneflex-solo-access-point-110-0-0-0-663-ga-softwar...

Once the AP is connected to a ZoneDirector, it will be given another new ZD-specific firmware image by the ZD.

I'd recommend factory-resetting the AP after you've changed the firmware image.

Hope that helps,
Darrel.

alan_tam_ell5st
New Contributor III
Thanks a lot for your value information. I will try to download the firmware that you mention.Is the any different between indoor ap software and solo access point software.

Thanks again.

Alan

DarrelRhodes
Contributor III
Hi Alan,

All APs, whether indoor or outdoor have their own, specific, firmware version for each of our software platforms: SmartZone, Unleashed, ZoneDirector and Stand-Alone.

Thanks,
Darrel.

hassan_rifki
New Contributor

Hi Alan,

I just bought two R610 with Software version 110.0.0.0.663.

Basically I need both R610 to coexist and run in the same facility as standalone, each one of them will be attached to my router, the 2 R610 will be providing clients IP thru my router..

first R610 doesn't seem to be working.. I may be doing a silly configuration error.

Any idea how to fix this?

Thank you 

Labels