I am trying to get my ZD1100 from 184.108.40.206.156 to 9.10, following the release note chain it appears I need to start with 220.127.116.11.44, however when I attempt to do this via ssh/debug/fw_update or the Web UI, the status orange LED never stops blinking. The serial console shows a few services shutting down (IIRC out of memory), but a login is still there, its as if, its stuck on something. It never reboots. I tried a factor reset. Did not make a difference.
I also get these messages non-stop on the serial console (this happened before trying to update the firmware):
mv: cannot create '/etc/airespider/license-list.bak.xml': Read-only file system mv: cannot remove '/etc/airespider/system.bak.xml': Read-only file system
mv: cannot remove '/etc/airespider/system.xml': Read-only file system
P.S. Just did another factor reset so I could collect all the logs, I get this error right after boot:
[INFO ] Just upgraded from 18.104.22.168.29
REISERFS error (device sda4): vs-4020 is_reusable: bitmap block 163840(8) can't be freed or reused
rm: cannot remove '/etc/airespider-images/rootfs_upgraded': Read-only file system
rm: cannot remove '/etc/airespider-images/upgraded.fromver': Read-only file system
rm: cannot remove '/etc/airespider-images/upgraded.frombld': Read-only file system
Thanks Abilash, however this ZD1100 is end of life and is not covered under support contract. (I purchased used). I was hoping to bring it back to life. This is for my own personal use/testing/learning. Is there anyway to force a recovery or reflash/reformat the flash?