Setting Rate Limits on SSID - not consistent with speed tests

[william_chard_7]

I have been using the rate-limiting feature for some time.  We are able to achieve the set rates on SSID's when we use the 10Mpbs or lower settings.  I need to be able to set the rate limit in 10Mbps increments for a Tiered Usage Model.   Setting it at 10Mbps I get close to the set rate. When I set it to 20Mpbs on up to 50Mbps my speed tests are dismal.  If I turn off rate limiting then my speed tests give me  the full 100Mbps connection.  

ZD 3000 HA Mode
Firmware 9.12.2.0 build 204  ( I just upgraded this ZD from 9.6 and I have all r710 and h500 AP's.  I have seen this issue across the firmware from 9.0 )

[hyosang_choi]

I have experienced siimilary result.

When I tested windows 7, rate limit works good.

But when I tested Android, Upload rate limit works bad.

When I configured 10Mbps, Upload go up to 100Mbps.

Download rate limit works good.

[william_chard_7]

I have tested this from windows , IOS and OSX

Thank you Robert

[william_chard_7]

Hey Rober, and luck on the new Lab set up?

[robert_lowe_722]

Hi William, not yet im afraid. Just waiting on a new controller to be delivered in next couple of days

[robert_lowe_722]

Hi WIlliam, sorry for the delay. Finally got round to testing this morning on the new controller. ZD1200 9.12.2.0_204 Ruckus R310 AP & Android client. Uncapped speedtest was 32Mb down & 14Mb up, rate limiting at 12 & 14Mb showed speed to hold true to capping no significant under performance.