Set MTU on Ruckus R500

[bnelSA]

Hi everyone,

I hope you're all doing well.

Does anyone know how to set the MTU on the R500 AP via CLI? 

I have done this before years ago but cant remember how to do it.

[bnelSA]

I tried but it doesn’t seem to work.

I keep getting command not recognised. How do I get into rkscli?

when I ssh into device, tried from there. Tried enable, config and system. Same result 

[vasanth_edward · Accepted solution]

Hi @bnelSA,

If my understanding is correct you are using Unleashed in the network.

In that case, try below commands, it should work:

ruckus> en

ruckus# ap-mode

You have all rights in this mode.

ruckus(ap-mode)# set mtu eth0 1200

Regards,

Vasanth Edward

[bnelSA]

That’s the part I was missing. Thank you so much Vasanth.