Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

[rick_pan]

The Port3 connected to Router with DHCP. Wifi is working fine. How do I configure the other two Ethernet ports as a simple switch that can connect to the router on Port3?

I see Trunk Port, Access Port, or General port. just don't know which and the rest of the settings.

[thomas_fankhaus]

Trunk Port should be fine.
Have you tried it allready?
Thomas

[rick_pan]

Not sure about these settings:

Packet Forward: Isolated, Bridge to WAN, Local Subnet NAT and Route to WAN, or Bridge to L2TP Tunnel?
802.1x: Disabled
VLAN: UNTAG ID:1
Insert DHCP Option 82: Disabled

[syamantakomer]

Hi Rick,

By default APs ports works as passthrough ports.

One of the ports will connect to uplink switch/router and other ports you can be used as passthrough ports (just like a bridged switch port).

Please note that connecting multiple interface of the APs to same switch/router may cause loops so avoid that.

If you could share a simple topology which explains what you are trying to achieve will help here. 

Regards,
Syamantak Omer

[rick_pan]

Here is a simple topology image attached. Just want to know the correct settings to make the Port 1 and Port 2 act as a simple switch.