Hi all,
I recently came into the ownership of 3 of these APs. Two I've been able to fix and side-grade to Solo firmware, however the third AP I'm running into major issues.
I bought a POE injector that is known to output the correct 802.11at power spec. When plugging everything in, the AP powers on, but the data activity lights on the port do not.
I have attempted to reset the unit multiple times to no avail. When powered on, the PWR and CTL lights blink green about once per couple seconds.
I believe this unit was previously setup on ZD, so I've been connecting it directly to my PC so it doesn't attempt to contact the cloud for previous configuration settings.
I've done a bit of troubleshooting with a local community and they seem to think the IC is toast.
Any ideas what could be going on here?
