Ruckus R700 converted to standalone mode and now DIR light is blinking

[perry_glover]

I installed the standalone firmware on a R700 AP that was running the Zone Director firmware. Now the DIR light on the AP is blinking green. 

How would I stop the DR light from flashing with the standalone firmware installed? 

[syamantakomer]

Please run below command and check the status after reboot.

set scg disable
reboot

Also provide the output of below command.

get version

Regards,
Syamantak Omer

[perry_glover]

That worked. The DIR led light is off now.

The Standalone firmware version I'm running is 110.0.0.0.675.

[syamantakomer]

Great!

"scg service" was enabled means AP was capable of finding a v/SZ/Cloud controller and that is why control traffic was generated and that is what DIR LED was indicating.

Regards,
Syamantak Omer