R720 Unleashed fast flashing CTL LED

[michael_liu_cea]

I am running newest Unleashed firmware. Was trying to do a factory reset but lost power before procedure can complete. Now I can't access GUI via 192.168.0.1 and CTL flashes fast. Can this unit be recovered?

Thanks.

[tony_heung]

Best option is to open a support case with our technical team who can provide further assistance on the hardware reset and verify the flash status.

[syamantakomer]

Hi There.

Try doing a factory reset by pushing and holding reset button for 12 seconds. Once done, try to access default IP or DHCP assigned IP.

If still not working then open a case and they will verify.

Regards,
Syamantak Omer

[michael_liu_cea]

Thanks, got it working now.

I have ran into another issue. I am using AC power supply (740-64277-001/ 48V .75A). In GUI, I got a warning stating "not enough electricity power provided". Do I need to configure the AP to recognize its getting AC power source?

Thanks again.

[syamantakomer]

Not required.

Wait for sometime, error should disappear automatically.

If not, then you may have to check.

Regards,
Syamantak