I have an R510 AP that I am trying to use in stand alone mode. I have 3 networks I want to bring down to the AP using the ZoneFlex firmware
- VLAN 10 - MGMT = This is the network I want to assign the IP to the AP to manage it.
- VLAN 20 - Wireless = Main wireless network
- VLAN 40 - Guest = Guest network
Configuration scenarios I have tried:
A:
R510: Under the Management Interface I have set the VLAN to 10 and assigned the IP.
Cisco 2960G switchport mode trunk
switchport trunk native vlan 10
switchport trunk allowed vlan 30,40
B:
R510: Under the Management Interface I leave this set to default VLAN and assign the IP
Under interface eth0, confirmed it is a Trunk port and set the untagged to VLAN 10
Cisco 2960G switchport mode trunk
switchport trunk native vlan 10
switchport trunk allowed vlan 30,40
C:
R510: Under the Management Interface I leave this set VLAN 10 and assign the IP
Under interface eth0, confirmed it is a Trunk port and set the untagged to VLAN 10
Cisco 2960G switchport mode trunk
switchport trunk native vlan 10
switchport trunk allowed vlan 30,40
😧 R510: Leave all VLANs to vlan 1 and set IP in the range
Cisco 2960G switchport mode trunk
switchport trunk allowed vlan 10,30,40
I then flashed the R510 to the Unleased software to see if that was any better. Easier -- yes. Does what I want -- No.
The only way I can get the AP to function the way I want to is to use BOTH ports on the AP:
eth0 - gets the mgmt IP and the switchport configured as an access port on that network
eth1 - set as trunk on default (1) with the client LANs trunked down to assign to WLANS
I do not want to have to run 2 cables to this AP when I put it where I want it.
Has anyone done anything like this and can help me?
