cancel
Showing results for 
Search instead for 
Did you mean: 

Lost access to AP after changing image

AlekShu
New Contributor

Hi everyone! 
After changing the binding on the H510 access point from H510_200.7.10.202.145 to H510_114.0.0.0.1360, then I can't go to its web interface. All attempts to register an IP or log in from the one that was given to her by the router did not work, tell me what can be done? Or is there a way to flash the AP in some other way to return Unlieshed?

In my country do not much know about Ruckus unfortunately… so please halp!

7 REPLIES 7

Please use a laptop to access the AP, instead of SSH, access the AP's web UI and then upgrade the AP. If still not working then please open a case with support team.


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

IMG_5521.jpeg

AP is fine, you cannot configure AP on standalone firmware with Unleashed app.

SSH access shows you have access to AP CLI.

Please run below commands, access the AP's web UI and upgrade it back to Unleashed.

get version

set http enable

set https enable


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn