I'm configuring an R710, going through the initial setup. I factory reset the device and I can ping the default IP 192.168.0.1, however I cannot access it via the web or through SSH. There's a strong possibility that this device was once configured with a ZoneDirector, I've read that might be the problem. I'm new to Rukus and I just want to know if there's anything I can do in this situation without going through ZoneDirector, which I've never used before.
Sorry for being late to this discussion, but I think this might help someone later. I have just received my R710 today.
Using the DC power adapter, went with resetting the device, it came up alive after 30 seconds or so. Tried hooking up non POE gbit links to each ethernet ports, but the default 192.168.0.1 address was just unreachable via ICMP echoes (ping). Then I decided to run an NMAP ping scan (nmap -sn 192.168.0.0/24) off of my 192.168.0.0/24 subnet and it yielded an unknown IP:
Nmap scan report for 192.168.0.67
Host is up (0.00s latency).
MAC Address: xx:xx:xx:xx:xx:xx (Ruckus Wireless)
And voila! It responds to ping and able to communicate on http port using 192.168.0.67 IP address.