Indoor AP's - How to scan LAN ports for neighbouring devices through CLI

[shane_hartigan]

Hi guys,

I need the ability to check if I can see another devices MAC address over the LAN port on the AP? I've searched for a command for a bit, but I'm failing to find anything.

Additionally, is there an option to do a cable test via the AP instead of a switch.

Thanks

Hrvoje

[abilashpr]

Hi Hrvoje,

I understand that you would like to know if, you are able to discover neighbors that are connected to Ruckus AP from Ruckus AP command line, please correct me if I am wrong.

rkscli: get lldp neighbors
-------------------------------------------------------------------------------
LLDP neighbors:
-------------------------------------------------------------------------------
Interface:    eth0, via: LLDP, RID: 1, Time: 86 days, 21:21:38
  Chassis:
    ChassisID:    
    SysName:      SW-S8.www.spaceway.com
    SysDescr:     Cisco IOS Software, C3560 Software (C3560-IPBASEK9-M), Version 12.2(55)SE12, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Compiled Thu 28-Sep-17 02:04 by prod_rel_team
    MgmtIP:       
    Capability:   Bridge, on
    Capability:   Router, off
  Port:
    PortID:       ifname Gi0/9
    PortDescr:    GigabitEthernet0/9
    PMD autoneg:  supported: yes, enabled: yes
      Adv:          10Base-T, HD: yes, FD: yes
      Adv:          100Base-TX, HD: yes, FD: yes
      Adv:          1000Base-T, HD: no, FD: yes
      MAU oper type: 1000BaseTFD - Four-pair Category 5 UTP, full duplex mode
    MDI Power:    supported: no, enabled: no, pair control: no
      Device type:  PSE
      Power pairs:  signal
      Class:        class 3
      Power type:   1
      Power Source: PSE
      Power Priority: low
      PD requested power Value: 13000
      PSE allocated power Value: 13000
    UPOE:         0
-------------------------------------------------------------------------------
OK
rkscli:

Hope it helps!!!

Regards,

Abilash PR.