10-21-2020 07:39 AM
10-28-2020 01:25 AM
You can use the "set director " command to change the controller IP address.
As the AP still have the old configuration it will go there.
option 43 is only if the AP is factory reset and it needs to find it's controller.
regards
Martin
10-28-2020 01:29 AM
Thanks martin but how can I use the command remotely? I am not able to log on the AP's, I hoped to do that using ssh but it does not recognize the Zonedirector admin credentials
10-28-2020 01:33 AM
Do you still have access to the original ZoneDirector?
You can use the remote ap cli command when you ssh into the ZD.
remote ap cli
regards
Martin
10-28-2020 01:47 AM
Yes, I can ssh on the old ZoneDirector...I even can see the AP's config with "show ap mac ...." but hoe can i modify the director IP?