cancel
Showing results for 
Search instead for 
Did you mean: 

I can't run speedflex on the AP that is connecting to the controller .

hayder_al_windi
New Contributor III
I can't run speedflex on the AP that is connecting to the controller . got an error that AP not have speedflex running or is behind NAT , any idea
3 REPLIES 3

sanjay_kumar
RUCKUS Team Member
Hi Hayder,

Is the AP behind the NAT environment before reaching the Controller?

If not, is there a Firewall between the AP and the controller?

Port 18301 is used between the AP and the controller, make sure to allow it (Both TCP and UDP).

The rule should be as below:

Traffic from Controller to AP, source port ANY, destination port 18301
Traffic from AP to Controller, source port 18301, destination ANY

hayder_al_windi
New Contributor III
Thank you Sanjay
yes the AP behind NAT environment 

sanjay_kumar
RUCKUS Team Member
Hi Hayder,

I'm not sure if this works when the AP is behind the NAT, as per some old cases. However, you can try checking the Firewall policy which I mentioned earlier.