How enable 160 Mhz or 80+80 MHz on AP r730

[namezys]

Hey,

I'm trying to use Ruckus R730.

I found confusing information in different documentation:

* it's clear that it supports 20/40/80 Mhz

* in some places (for example documentation about ZC) I can see that it can support 80+80/160

To check how it works I installed vSZ v6.0.0 (the last version that has firmware for this AP, v6.1 uses old firmware)

But in the interface, if I'm trying to override parameters for 5Ghz I see only options for 20/40/80.

Also, it is connected using a 48V (at least 2A) DC adapter.

Does it actually support 80+80/160 Mhz and can I active it (even in SOLO mode)?

Thank you.

[Orlando_Elias · Accepted solution]

Hello @namezys 

I found in the datasheet for the R730 this is what they support:

https://webresources.ruckuswireless.com/datasheets/r730/ds-ruckus-r730.html

This is how it looks like in the datasheet for the R650 which supports 80+80

Let me know your comments or questions.

[namezys]

Hey @Orlando_Elias 

Yes. I saw it. If in other places there are same information, it will be clear. However, there are different opinions.

Also:

From "Ruckus Indoor Access Point Release 110.0 User Guide"

There are table for different POE modes:

• 802.3at - 160/80+80: NO
• 802.3at+ - 160/80+80: Yes 2x2
• Full power - 160/80+80: Yes 2x2

BTW I don't fully believe to this because for Full Mode there is limit to 4x4 in compare to 8x8 for 802.3at+.

So I was unsure. Maybe at time of release there was only 80 MHz mode but later was a software update. Or something else. 

[Orlando_Elias]

Hello @namezys 

Thanks for highlighting that.

First, I don't think the AP R730 supports the solo version 110.0.x It's my understanding that the R730 starts with 112.1.x

Please let me know fi you have any pending concers and I will be happy to clarify and even will fix any confusions in the documentation to make the information clearer.

[namezys]

Yep. Looks like you are right. I tried to do it from CLI in both SZ and SOLO mode. This setting was not accepted.

As I know the chip is support it. However, there is no chance that software will be updated. I'm right?

Also I see very low performance in SOLO mode. I will do more test and create new topic as soon as I will have time. I hope that it can be adjusted from CLI. This AP looks like ugly duckling.