H510 unleashed and several r300

[Skynet]

Can we obtain a goal of seamless roaming with a single h510 unleashed and the rest 10 ap’s a mix of r300 and probably even lower gen models like 7962?

no controller

[Vásquez_Fer]

Hi @Skynet 

Hope you are doing great !

I hope I have understood your query

One of the requirements to have an unleashed network or take in consideration is that the wireless access points must have the same firmware version.

In your case, the AP 300 does not have this capacity nor does the 7962 to run any unleashed version therefore they cannot coexist in an unashed network.

I leave  a couple of screenshots  , the unelashed versions start with 200.x.x.x  as the example of the H510

More information:https://www.commscope.com/globalassets/digizuite/61796-ds-unleashed-portfolio.pdf

Best regards

Fernando Vasquez

[Skynet]

thank you! But still not everything is clear.
In the pdf you attached neither r500, nor r600 are listed, however I know they have unleashed versions as well

[Vásquez_Fer]

Hi @Skynet 

Thanks for the reply! These devices are end of life for that reason does not show up in the unleashed  pdf, I attached the unleashed PDF as reference to know more about unleashed and some actual support APs.

As I mentioned unleashed versions start from 200.x.x.x which we can go AP by AP to check if it runs any unleashed version

Here:https://support.ruckuswireless.com/software

In the Choose Product you can selec any disired AP

 

Then Check the fimware versions available

Or you can check the release notes in each version example

Best regards

Fernando Vasquez