4 Standalone R600 access points

[ap]

Hello,

I have 4 R600 access points running firmware 9.13.3.0.145. The zonedirector died so I converted them to standalone. What is the current best way to have these access points set up, would it be converting them to Unleashed or leaving them as is?

What is the latest firmware version I should install? Thanks!

[Ayush_Tripathi]

hello @ap 

The highest supported version for the R600 AP in unleashed code is 200.7.10.202.145.

https://support.ruckuswireless.com/software/3779-ruckus-unleashed-ap-200-7-mr-refresh8-software-for-...

Please refer the below article to convert ZD managed AP to unleashed

https://support.ruckuswireless.com/articles/000005720

[ap]

Thank you, Ayush.

Is the best option to run the access points in unleashed 200.7.10.202.145? Or is there a better way I should configure them?

[ap]

Thank you, Ayush.

Is unleashed the best way to reconfigure the access points rather than leaving them in standalone mode with the same SSIDs? Or is there a more recommended configuration?