On a Zone Director during the Setup Wizard if you enable Mesh it disables TX Auto Power Management. Can TX auto Power management be enabled for non mesh configured access points or is rendered non functional for all AP's
The issue I had was that the client did not support one or all of 802.11i,r&k. To resolve this I disabled them within the particular WLAN setting on my Zonedirector.One other option is to see if there are any firmware updates for your Wireless Net...
Hi Sandy,Try disabling 802.11i,r&k I have had clients that would not join a WLAN with 802.1X authentication with these one of these on. cannot remember exact which of the those amendments it was exactly which resolved my issue. RegardsShane
