CommScope RUCKUS Community Forums

Hi Every one,I have ICX 7150-24, and my firmware is SPS08080d.bin as primary. The Openflow is not supported. When a run SPR08080d.bin as secondary, then it supports OpenFlow commands. I am wondering is it possible to support OpenFlow in switch mode o...

Hello Everyone,I have ICX 7250-24 switch and ODL oxygen version. I have connected the ethernet interface 1/1/1 to the  ODL controller. the controlling is running on ip address 192.168.2.25 port 8181. I have enabled the openflow ofv130 and have connec...