Hi,following situation:#SSID1 and #SSID2 are both in tunnel mode and in same VLAN (900).When a Airprint enabled printer is connected to #SSID1 and an Apple client is connected to #SSID2 on the same AP, everything works as expected.When the printer is...
Just create an empty WLAN Group (a WLAN Group without any WLAN object) and set this WLAN group as override on the 2,4 GHz section in the AP Group configuration.This is how we disabled 2.4 GHz for certain AP groups.
We do not have an open case regarding this right now, because I'm afraid the "standard solution steps" will take so much time compared to the outcome, so that we currently wait for a fix hopefully within the next firmware update.But I get your point:...
We have a similar issue with R730 APs. Everything is working fine for some days but suddenly, clients do no have network access when connected to these APs. Only an AP reboot fixes the issue for some time until it happens again. We have APs on firmwa...
IoT is very good hidden at Ruckus This is the correct IoT supported vSZ controller: https://support.ruckuswireless.com/software/1831-ruckus-iot-1-1-ga-software-release-ova-vsz-e-vsz-hvscg-3.6.1.2.12010.ova Best regardsSven
