Hi Alden,When executing "show meminfo" command, can you also check the Buffers and Cached memory? You should also see them in the output of the above command.The Buffers and Cached Memory can also be considered as Free Memory and both can be reclaime...

Good day Alexey,The answer to your question is that you cannot form a cluster with different firmware versions. If one SZ is on an older firmware then its better upgrade it to the version currently running on second SZ and then you will be able to fo...

Hi Chris,This is basically decided based on the Response Window (Timer). When the SZ (Acting as Radius Proxy or the Authenticator) sends Radius packets to the Primary AAA and does not get a response back within the Response window then it starts send...

Hi Philip,dot1x is a Layer 2 authentication where the client does not have an Ip address before authentication. Client gets an Ip address only AFTER the authentication is complete. i.e after the client has got EAP Success from Authenticator and encry...

The client devices are perhaps getting enough strong signal to stay connected to the AP upstairs.. if I were in your position I would perhaps reduce the Tx power on second floor AP to half or lower so that clients that are closer to it only connect a...