CommScope RUCKUS Community Forums

highspeed_syste · 05-10-2016

I have an installation that consists of the following.1 Mikrotik Gateway3 Mikrotik Point to Multipoint Antennas10 Mikrotik Bridges connected to the PTMP antennas1 Zone Director22 AP's distribuited through 10 buildings.Problem: When I enable captive ...

highspeed_syste · 05-12-2022

Hi Syamantakomer. I have the same problem with an H510. I have factory-reset the WAP, and it is broadcasting the SSID "Configure.Me-XXXXXX", but it is requesting an encryption key. I have tried the 12-digit serial number with no success. Have factory...

highspeed_syste · 05-10-2016

Thanks, that's great information! We'll upgrade a ZD/test this in the lab and will post back if we have any more issues.Thanks for all your help!Derek

highspeed_syste · 05-10-2016

Ah I see, no we don't have that option (running 9.5.2.0 - 15) Will adding the MAC's to the L2/MAC Access Control and applying that ACL to the WLAN help or do we need to upgrade the ZD.Thanks

highspeed_syste · 05-10-2016

Thanks, I don't see a Client Isolation whitelist.. do I use the L3/4/IP address Access Controler and put the IP of MikroTik in here? Also, under configure--WLAN-- Access Control the L3/4/IP is greyed out... should I just enter the MAC in ACL and if ...

highspeed_syste · 05-10-2016

Thanks for the quick reply Andrea, in our trial and error, it seems enabling option 82 on the WLAN on the ZD worked (we were able to get the login page) The only problem is that it only works when full client isolation is disabled (local is enabled),...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Mikrotik Hotspot + Zone Director

Re: Configure.Me-xxx of second AP requires password

Re: Mikrotik Hotspot + Zone Director

Re: Mikrotik Hotspot + Zone Director

Re: Mikrotik Hotspot + Zone Director

Re: Mikrotik Hotspot + Zone Director