Hi there,
I just setup my Zoneflex 7982 and noticed some repeating errors in the log file.
5ghz Radio:
Wireless mode: 5ghz
Channel: SmartSelect
Channel Width: 40mhz
Country Code: New Zealand
Running software version: 9.6.0.0.267
In the log fi...
Merry Xmas all,
Thought I'd let you know that Ruckus have fixed the bug in releases 9.6.2.0.13 and 9.7.0.0.220 which are available for download here https://support.ruckuswireless.com/so...
I'm using 9.7.0.0.220 as I'm only using a standalone 7982
...
If you don't want to switch to 20mhz then you can just blacklist the offending channels, for me there was about 3 of them
Just ssh into your AP and run:
set blacklist wifi1 xxx -1
Where xxx = channel number
My AP is standalone, not sure it matter...
Hi Keith,
Much appreciated.
I changed the country to Australia out of interest, same deal. Suspect it'll affect anyone in the same region that Australia and NZ are in
Cheers,
James
When I go with 20Mhz, smartselect starts off on the lower channels then jumps up to 108+ within a few minutes. There's no other 5ghz AP's around me and it seems to detect interference a lot, this normal?
It seems my MBP 2010 doesn't support some of ...
