CommScope RUCKUS Community Forums

teza_han · 03-08-2014

Just installed four 7731 radios to connect to our remote office. We needed to put two of them at a location in the middle since we did not have line of sight. At that location, the two radios are patched using a cat6 cable and each of them is pointed...

teza_han · 03-17-2014

Changing the distance did not make any difference for me. Yes I've ran channel scan but I only get results on the root bridges. The non-root always comes back with an empty list.

teza_han · 03-13-2014

Now that I look at the distance again, I see that it can go in 1km increments. The first time I looked at it, it only went in 2km increments. Maybe because of the channel I selected at the time. I will change the distance to reflect the real distance...

teza_han · 03-13-2014

Thanks Gary. I found the distance, after getting it to work with a different channel and have set it as well. For me it's 3km for the first leg and 1 km for the 2nd, so I set it as 4km and 2km respectively. I thought the distance was set by the insta...

teza_han · 03-10-2014

Thanks Keith. There was a 1Gb dumb switch connecting the two radios at the middle location, but i've asked the installer to remove that and patch the radios directly. That did not solve the issue, but selecting a different channel solved it for now.

teza_han · 03-10-2014

Changed the channel at site 1 to a different channel and I am getting about 72 Mbps now which is a lot closer to what speed flex was giving me. Not sure why that would be the case as I would assume a channel issue to affect both speed flex and comput...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Zoneflex 7731 Throughput

Re: Zoneflex 7731 Throughput

Re: Zoneflex 7731 Throughput

Re: Zoneflex 7731 Throughput

Re: Zoneflex 7731 Throughput

Re: Zoneflex 7731 Throughput