CommScope RUCKUS Community Forums

nicholasrogers2 · 01-15-2025

I followed the instructions in this article RUCKUS Forums - How to perform a Software recovery on an ICX7150 s... - CommScope RUCKUS Community Forums however after installing the SPS08090k.bin image file using the Putty command line, the switch would...

nicholasrogers2 · 01-16-2025

In order to fix the booting issue after the power outage I followed the steps in an older article for firmware FastIron 08.0.90k (GA) (SPS08090k.bin) with boot file mnz10115.bin. Which is the correct firmware to update to?

nicholasrogers2 · 01-15-2025

The lights are green and the switch and access points are working as they were before the power outtage as far as I can tell. I am just concerned if installing only the older version image file will cause any issues down the road or if this will need...

nicholasrogers2 · 01-15-2025

Hi, I have followed the outlined steps but still do not see any console messages after opening Putty, it does not appear to be entering boot mode.

CommScope RUCKUS Community Forums

User Statistics

User Activity

Fixing Ruckus Switch After Power Outage

Re: Fixing Ruckus Switch After Power Outage

Re: Fixing Ruckus Switch After Power Outage

Re: PuTTY will not run boot using the COM connect through USB adapters