CommScope RUCKUS Community Forums

Hi Thedavewarren,If you're looking to configure a new T610 AP, here's how:Access the AP using its default factory IP address (192.168.0.1) via SSH.If the AP is connected to a network and obtains an IP address via DHCP, use SSH (for example, with PuTT...

Thanks for the logs, can you please access the AP CLI and manually assign controller IP on the AP:- set scg ip <ip-addr of the controller>

Thank you for the information, I would request you to verify the license count on the controller(should be enough to support 42 APs)If DHCP opt 43 is not enabled, please access the AP CLI and manually assign controller IP on the AP:- set scg ip <ip-a...

Hi Elnoor,Thank you for writing to us. I can understand from your statement that APs(R350 & R650) are disconnected from the controller .(please correct me if I am wrong)Please share me the following details to better understand the issue:- When you e...

Hi Haderthon23,Thank you for contacting us, Could you please help me with the LED Status for CTRL and PWR, are they steady green?If yes, then it's because WLAN services are down. To confirm, I'll request you to share me the following output from the ...