CommScope RUCKUS Community Forums

emil_k · 11-19-2021

Hi all I recently bought a R710 running unleashed. Initially everything was working. However I was experiencing bad throughput and read somewhere on here that I could try to install an older firmware. So I installed/downgraded to https://support.r...

emil_k · 11-19-2021

Hi Sarita an Syamantak I am performing the factory reset exactly as described. But unfortunately it seems like the process is interrupted by the continuous restarts. Just as expected I am able to access the AP for about 5 seconds after it has b...

emil_k · 11-19-2021

It also seems like the factory reset process is interrupted by the reboot.

emil_k · 11-19-2021

The previous version was 200.10.10.5.253 and its the only ap on the network. I have tried the factory reset procedure you describe multiple times without any luck. I see the power led flash red and green very fast for a couple of seconds and then ...

emil_k · 11-19-2021

I assumed this was a safe operation since according to the release notes the R710 is supported and further states: Admins should be careful not to accidentally downgrade an AP to an Unleashed build that does not support that AP model. If this doe...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Restart loop after firmware downgrade

Re: Restart loop after firmware downgrade

Re: Restart loop after firmware downgrade

Re: Restart loop after firmware downgrade

Re: Restart loop after firmware downgrade