Hi everyone,I have a ICX7150-C12 with two APs (via DHCP) that is connected to a pfsense router.The router has the IP 10.23.1.1 and the switch shows the IP 10.23.1.2 when I log in via the console port. In unleashed the switch is shown as 10.23.10.2. E...
Hi everyone,
we just built a house and we have the following network components:
Netgear R7800 router with OpenWRT
Ruckus ICX7150-C12P switch
2x Ruckus R320 APs (one on each level)
I am completely new to Ruckus, VLANs and OpenWRT. My target is to...
It seems like I got everything set up properly now. There was also quite a big portion of config necessary on the OpenWRT router side necessary.
@Vijay_Kuniyal Thanks so much for your help!
@Vijay_Kuniyal Thanks again! Probably a stupid question. Would you recommend to use the switch as the dhcp Server or the router. At the moment it is the router.
OK, I got the router image installed and "working" - baby steps. Still issues:
1. I cannot log into the switch with ssh anymore. The serial port works well, but is in another room. Would like to log-in via any ssh device again
2. I added the inte...
