CommScope RUCKUS Community Forums

kem · 02-23-2021

Hello! I want to upgrade our 5.1.2 2xvSZ+2xvDP to 5.2.1 latest. But I found from SZ-5.2.1-UpgradeGuide-RevA-20200731.pdf on page 23 this note: "For remote APs connected over a VPN, the tunnel MTU must be reduced to 1400 (acceptable range is: 850 th...

kem · 02-28-2021

OK, thank you very much, it is good to know. I was most worried about a possible change by controller part that the former setup wouldn't work anymore after upgrade while all the rest of the infrastructure is the same.

kem · 02-26-2021

Hello! Can you please specify if this is really a change since 5.1.2? Because 5.1.2 was our initial setup and it all worked over those VPN channels and is currently in use. Our system has over 100 AP-s and that would be a disaster if the upgrade won'...

kem · 02-24-2021

I just saw that yesterday 5.2.2 became available and when going to the release notes (SZ-5.2.2-UpgradeGuide-RevA-20210215.pdf) to the very same place on page 23, this note has been removed. I can't find mtu being mentioned in this file elsewhere too ...

kem · 02-23-2021

(I can't post normally for some unknown reason so I had to cut the text and now I add the rest as a separate post.) My question is: has anyone really upgraded the controller (vSZ+vDP) having AP's behind IPSEC-tunnels? Has this MTU really been an iss...

kem · 02-23-2021

I just can't post normally, what's wrong? I try different ways and formatting and editing, then finally something works but there is error message "Failed to update comment, please try again." So I add the crucial 4th point about the LDAPS as a phot...

CommScope RUCKUS Community Forums

User Statistics

User Activity

vSZ upgrade to 5.2 with AP's over tunnels

Re: vSZ upgrade to 5.2 with AP's over tunnels

Re: vSZ upgrade to 5.2 with AP's over tunnels

Re: vSZ upgrade to 5.2 with AP's over tunnels

Re: vSZ upgrade to 5.2 with AP's over tunnels

Re: vSZ 5.1.x Administrators - Active Directory