zone director 1100
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2020 10:22 AM
I have zone director 1100 in that ethernet port not functioning ....... so is there any other option like configure this zone director using console....
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2020 10:37 AM
Hi Pradeep,
ZD1100 comes with two 1 Gig ports. Could you check if both ports are not working or just one.
If both eth ports are not working then device cannot communicate with network, so you have to replace this device.
Even if you configure things from CLI, how ZD will communicate with network. It needs network connection over eth ports for AP/ZD communication and internet.
Regards,
Syamantak Omer
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn
ZD1100 comes with two 1 Gig ports. Could you check if both ports are not working or just one.
If both eth ports are not working then device cannot communicate with network, so you have to replace this device.
Even if you configure things from CLI, how ZD will communicate with network. It needs network connection over eth ports for AP/ZD communication and internet.
Regards,
Syamantak Omer
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-20-2020 11:16 AM
ZD Console access settings per KBA-4232:
When trying to access ZD via console cable these value's needs to be as used.
Ruckus Zone Director Console baud rate is 115200. and we use 1 stopbit, 1 data bit, no parity, no flowcontrol.
When trying to access ZD via console cable these value's needs to be as used.
Ruckus Zone Director Console baud rate is 115200. and we use 1 stopbit, 1 data bit, no parity, no flowcontrol.

