cancel
Showing results for 
Search instead for 
Did you mean: 

Zone Director 1200 Not Connected Web İnterface

ferdi_kilic
New Contributor III
Hi,

I can not access the device 's web interface .
I need to reboot my reach .
After a while, it lost access happening again . The upper status LED flashes red . Then simultaneous wireless connections are breaking and coming back. Best regards
22 REPLIES 22

martin_martin
Valued Contributor
Are you sure, your network connections (switch) is stable ?
Did you use the original power supply of the unit ?

Did you try the second port of the ZD1200 ?

Kind regards
Martin

ferdi_kilic
New Contributor III
Yes Perfect network no ping lost. No wired network problems.
MASS POWER AC ADAPTER
P/N 740-64246-011
Model:wgf-1200200M2
INPUT:100-240 v 50/60Hz 0.6A
Output: 12.0V --2.0A

It called port 1 and port 2 

ferdi_kilic
New Contributor III
No problem when I run it standalone access points
I have this problem when I get to the circuit ZD1200

martin_martin
Valued Contributor
Can you give us more info on that ?
You mean when you set the access points as standalone, you can access the webgui from the ZD1200 again ?
if so that looks like a network ip addressing issue.

you should be able to see what happens when you do a packet trace between the ZD1200 and the switch. (most switches, Cisco / HP you can setup a port as monitoring port and connect to that with wireshark).
Labels