Zone Director 1200 Not Connected Web İnterface

[ferdi_kilic]

Hi,

I can not access the device 's web interface .

I need to reboot my reach .
After a while, it lost access happening again .
The upper status LED flashes red .
Then simultaneous wireless connections are breaking and coming back.
Best regards

[martin_martin]

Are you sure, your network connections (switch) is stable ?
Did you use the original power supply of the unit ?

Did you try the second port of the ZD1200 ?

Kind regards
Martin

[ferdi_kilic]

Yes Perfect network no ping lost. No wired network problems.
MASS POWER AC ADAPTER
P/N 740-64246-011
Model:wgf-1200200M2
INPUT:100-240 v 50/60Hz 0.6A
Output: 12.0V --2.0A

It called port 1 and port 2 

[ferdi_kilic]

No problem when I run it standalone access points
I have this problem when I get to the circuit ZD1200

[martin_martin]

Can you give us more info on that ?
You mean when you set the access points as standalone, you can access the webgui from the ZD1200 again ?
if so that looks like a network ip addressing issue.

you should be able to see what happens when you do a packet trace between the ZD1200 and the switch. (most switches, Cisco / HP you can setup a port as monitoring port and connect to that with wireshark).