Unable to access Director Login Page
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2020 10:45 AM
I am trying to log into the Zonedirector 1100. When I type in the IP Address of the zone director I am redirected to http://x.x.x.x/ToHttps.jsp.
I have tried using IE, Firefox, Chrome, Edge and all behave the same
I have rebooted the zonedirector and I have tried logging in via the wired network.
any suggestions?
I have tried using IE, Firefox, Chrome, Edge and all behave the same
I have rebooted the zonedirector and I have tried logging in via the wired network.
any suggestions?
3 REPLIES 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-26-2020 11:07 AM
Hi Corey,
It seems ZD's management ACL is enabled and it is not letting you access the GUI.
If you know what IP/subnet is allowed on management ACL then you can access the ZD.
If not, you have to access ZD using it's console port and disable the management ACL.
Refer below article for more information.
https://support.ruckuswireless.com/articles/000001541
Regards,
Syamantak Omer
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn
It seems ZD's management ACL is enabled and it is not letting you access the GUI.
If you know what IP/subnet is allowed on management ACL then you can access the ZD.
If not, you have to access ZD using it's console port and disable the management ACL.
Refer below article for more information.
https://support.ruckuswireless.com/articles/000001541
Regards,
Syamantak Omer
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-11-2020 03:37 PM
Easiest way to fix this is to upgrade its firmware to I believe anything after 9.8 via tftp. I have had this happen on older zd1100s that were firmware neglected.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2020 05:03 AM
Hi Tommy,
What you are referring is a different issue with ZD 9.5 version where TLS 1.2 cipher suite is not supported, so modern browsers will not allow a connection (modern browsers stopped TLS 1.0 long back) and you get an error on page ,when you access it.
Regards,
Syamantak Omer
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn
What you are referring is a different issue with ZD 9.5 version where TLS 1.2 cipher suite is not supported, so modern browsers will not allow a connection (modern browsers stopped TLS 1.0 long back) and you get an error on page ,when you access it.
Regards,
Syamantak Omer
Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

