11-02-2015 08:57 AM
I am having an issue.. This is brand new, I have configured it now 4 times and each time it always has the same issue. I am starting to think this is a hardware issue, or that it is just not going to work in our network. I have a Ruckus 1200 with ZoneDirector. The issue is that;
Once configured I can't authenticate into the WAP's, I get an error that indicates Authentication Error. If I set the WAPS to no password, open authentication, the same issue occurs.
Eventually the AP's that are connected (4 of them) will loose connection to the Zone Director and they won't connect at all, The DHCP on our network is setup for the client connections, but the AP's and the Zone Director use a static IP address, However the AP's don't ever get that address, They also eventually commit suicide and require me to get up on a ladder and hard reset them. Once they are reset the loop continues, where I am going through the same issues over and over again.
I can find them though on the network, and can remote into them, but the DHCP listed in the AP is not what I am using to connect to them.. The DHCP will show 192.168.0.1 as the address, but on my network they are in a different subnet, and it is what I am able to connect to.. I also can't find the 0.1 which shows on the interface as existing anywhere..
It was more simple to configure a Cisco PIX on a 12,000 Person network, with 300 VLans than it has been to configure this boat anchor.. Beyond pissed at this thing.. It's been 7 days of nightmare.
11-02-2015 09:12 AM
11-02-2015 09:39 AM
"192.168.0.1 is the default address that the APs take on when they are in factory default mode and do not receive a DHCP address from a DHCP server."
Yeah, I know, but the AP shows this address, but the address is in my case actually 192.168.2.13, which is in the DHCP scope, although the GUI shows 0.1.. Not really sure why.. But after I connect to it once at 2.13, I can't connect again to it at that address, if I flop to 0.3 for instance on a laptop, I can't see 0.1 and can't ping it, can't telnet to it, can't connect with the Web interface either..
"Just so I make sure I understand the issue clearly, have you attempted to log into the APs in factory default mode and issue them with static addresses? (via the AP web UI or ssh)"
Via Zone Director, I can see them in the zone director, but only for about 5-10min, doesn't seem to matter if I do anything or nothing, they just disconnect and throw errors that the heartbeat has been lost. Yet I can still ping them from a machine on the same network. I can also ping the Zone Director from the AP itself, but I can't ping the AP from the Zone Director..
"What are the ZD settings for APs?
Manual, DHCP or Keep AP's Settings?"
I have tried DHCP as well as Static, doesn't matter what I do, they eventually get sick of living and off themselves..
"If this is a silly question I apologise, Just starting with the basics :-)"
No worries.. It's not easy to explain.. Haven't had issues with things like this since Linksys..
11-02-2015 11:11 AM
11-02-2015 11:18 AM